Products

Home Products Charcoal Powder Extruder Details

Bbq Charcoal Machine

The charcoal extruder can produce carbon rods that meet the requirements according to your actual needs.

Send Inquiry

Features

Burning rod making machine principle:
The working principle of the coal stick machine is that the electric motor transmits power to the transmission through the V-belt. The transmission output shaft transmits the power to the propelling shaft through the floating coupling. The propeller on the propelling shaft pushes the coal material out through the forming die to produce Ideal for high pressure coal rods. Structural features:
(1) The feeding spiral lead is large, feeding is fast, and the propelling spiral lead is small, saving power.
(2) The shaft seat and the cylinder are rigidly connected, with high concentricity, resistance to reverse thrust, and stable machine.
(3) The part to be sealed adopts a fault structure, and dirt is leaked through the faults.
(4) V-belt drive, smooth operation, low noise, and also acts as overload protection.

(5)The machine head and the cylinder are connected with a snap ring structure and a bolt structure, which can be selected according to the user's needs.

Fuel rod extruder

Model	Capacity	Roating speed	Power	Model size
MK-140	2-3(t/h)	46-60(r/min)	11KW	30-40mm
MK-180	3-4(t/h)	38-50(r/min)	22KW	30-60mm
MK-300	6-8(t/h)	40-50(r/min)	40-50KW	30-100mm

Coal stick making machine notes:

1. Check the electrical control circuit of the coal stick machine for circuit errors, open circuits and short circuits.

2. Before starting the coal rod mill, add 2-3 liters of clean water into the rod mill to moisten the chamber, and open the cooling water valve of the gear reducer for more than 300 types of equipment.

3. The gap between the push rod and the coal inlet of the coal rod head is adjusted by adding or subtracting ring pads between the blade surfaces. Generally around 5mm. Under the premise of non-interference, the smaller the gap, the better, but it cannot rub against the machine head.

4. When temporary shutdown is required during work (generally no more than 2 hours), an appropriate amount of water should be added before shutting down to ensure that the moisture content is around 15%-20% to avoid water loss in the barrel and material drying during shutdown, so as to facilitate the following operations. Started successfully.

5. When restarting the coal stick machine after it has been shut down due to a fault, if it fails to start twice in a row, it should be stopped, check the cause and eliminate the fault or clear the material in the machine before starting again. If forced to start, the device may be damaged.

6. Current is the main parameter to measure the load of the coal rod machine and the degree of coal rod compaction, and is the main basis for the operator to control the equipment.

Carbon rod making machine

Fuel rod production machine operation:
The coal rod forming machine uses the working principle of spiral extrusion to compress the prepared pulverized coal into a predetermined shape with a certain strength. The coal rod extruder adopts a hard-tooth surface reducer, which is small in size and has high load-bearing capacity. The coal rod extruder adopts a hard-tooth surface reducer, which is small in size and has high load-bearing capacity. The internal impeller of the coal rod machine adopts a thickened blade design. The impeller and the inner lining plate of the cylinder are made of wear-resistant precision casting materials. The service life is 4-5 times that of ordinary materials; the coal rod outlet of the machine head is made of replaceable wear-resistant alloy. Made of steel, easy to replace.

Our team