Wood Biomass Pellet Machine

In general, in this case, we need to consider whether it is the raw material or formula of the pellets that makes the production change slow, or whether the formula can be changed quickly to achieve the desired results. After excluding the reasons of the raw material and formula of the pellets, we will analyze whether it is an internal problem of the pellet machine setting.
The mold is worn too much, the sieve holes are worn flat, and the expansion is serious, resulting in a reduction in the pressure on the pellets, affecting the pellet forming rate and causing too much powder.
The moisture content of the raw materials is too low or too high. If the moisture content is too high, there will not be too much powder, but the hardness of the pellets is low, and the pellets made by the feed pellet machine are easy to loosen. If the raw material has a low moisture content, it will be difficult to extrude and form, resulting in too much powder.

The feed pellet machine is aging, lacks power, and the motor cannot provide enough speed to generate the corresponding pressure to press into pellets.
The ring die is of poor quality, or the compression is not high enough.
Consider the amount of grease used.
The above are several reasons why the pellet machine cannot press into pellets. I believe everyone has understood it through the above introduction. If you need to know more about the pellet machine, please continue to pay attention to this website.