Electric Wood Pellet Mill

Small biomass pellet mill in the operation process, when adjusting the amount of feeding, as long as the thickness of the material in the feeding area is less than the large starting point of the pressing area, it will directly affect the effective working interval length of the pressing area.

wood pellet mill press zone, causing fluctuations in current and changes in hourly output. If the feed zone material layer thickness is greater than the large starting point of the press zone, it will have no effect on the hourly output or energy consumption per unit of time other than to increase the feed zone material layer thickness and will no longer cause a change in current and hourly output.

Wood chip pellet machine pellet cutting depth 3mm, cross distance 5~10mm. mold mouth should be flat, left and right height deviation is ±1mm. up and down deviation is ±2mm. however, pay attention to the adjustment time. The fluidity of the granular material is better, and at this time, the speed can be appropriately slowed down, so that the appearance of the biomass pellet machine is smooth and beautiful after pressing and molding.

Bamboo pellet machine

The assembly process of the fuel pelletizer involves several steps, including preparing tools and parts, installing the bearings, installing the oil retaining ring, installing the circlip, installing the spacer, installing the eccentric shaft and brushing with lubricant, and finally installing the gland. shaft and lubricating oil, and finally installing the gland.
Preparation of tools and parts: Tools to be prepared include hammers, circlip pliers, chisels, jacks, etc., while parts include pressure roller shells, bearings, eccentric shaft, oil retaining ring, gland, spacer ring, circlip, cover, check ring. nuts, etc.
Installation of bearings: First, clean the inside of the roll shell with a rag and brush with lubricant to improve smoothness. Then, put both hands into the bearing and make sure it is square. Take turns tapping the bearing so that it enters the pressure roller shell evenly and smoothly until it is flush with the section.
Install the oil retaining ring: Install the oil retaining ring into the correct position on the inside wall of the nip roll shell.
Install the circlip: Use circlip pliers to snap the circlip into the circlip groove and use a chisel to assist in fitting it into place.
Install the spacer ring: Put the spacer ring into position, pay attention to the direction to avoid installing the opposite.
Install the eccentric shaft and lubricate: Brush the eccentric shaft with lubricant and install it on the pressure roller shaft.
Final installation of the gland: Turn the gland clockwise and install it on the pressure roller shaft.

Home made pellet maker

The maintenance of the pellet machine is very important to extend its service life. Specifically as follows:
1. regularly check and clean the parts such as feeding port, discharging port and conveying pipeline.
2. keep the motor and transmission parts in good condition and add lubricant regularly.
3. regularly check and replace the wearing parts, such as blades, grate plate, etc.
4. carry out regular overhaul and maintenance of the pellet mill to ensure its normal operation.

Hot Tags: electric wood pellet mill, China electric wood pellet mill manufacturers, suppliers, factory, biomass pellet manufacturing safety, industrial wood pellet machine, pellet mill for wood pellets, wood pellet making equipment, pellet making equipment for wood pellet production, wood pellet maker