Charcoal Powder Rod Making Machine

Bamboo charcoal making machine

1. Before starting the machine, turn the pulley by hand to see if there is any jamming.
2. Before starting the machine, tighten the connecting screws of the heating tube and the three top screws of the inner sleeve of the heating tube.
3. Before stopping the machine for continuous work, the hopper materials must be unloaded, and reverse for one minute before stopping the machine.
4. When it is necessary to start production again, the temperature of the heating tube must rise to 350℃ before starting the machine, and less material can be unloaded. After the rod is sent out, a large amount of material can be unloaded.
5. The cooling water should be unobstructed.
6. During production, pay attention to whether the motor current and voltage are normal to prevent motor damage.
7. When the propeller cannot rotate, it should be stopped immediately, reverse, clear the hopper materials, and continue to heat up. After the original temperature is increased by 20℃, start the machine again and follow the original starting steps.
8. The outlet direction is facing the wall, the front is against the wall, and a wooden board is placed.
9. It is strictly forbidden to stand in front of the discharge port when the machine is turned on!
10. The electrical circuit should be kept dry and clean, and the power supply should be cut off when the machine is stopped.
11. It is strictly forbidden to let stones or iron filings enter the hopper. If any abnormality is found, stop the machine immediately.
12. All lubricating parts should be lubricated once every two months.
13. It is strictly forbidden to start the machine if the machine body is not well grounded!

Charcoal machine

Bbq charcoal making machine

Different models of charcoal stick making machines may have some slight differences in operation, so be sure to read the operating instructions of the equipment in detail before use and operate it in accordance with the requirements of the instructions. In addition, if you encounter a malfunction or abnormal situation during operation, you should immediately stop the equipment and contact professional maintenance personnel for maintenance.

Charcoal machine maker

Coal briquette machine

1. Crush the raw materials such as sawdust, rice husks, and various wooden scraps and waste into a diameter of about 3 mm, and dry them to a moisture content of 8%-12% for later use.
2. Open the machine base cover, add 2kg of engine oil to the refueling hole on the upper part of the rotating box, install the motor, the belt should not be too tight or too loose, too tight will easily damage the belt, too loose belt will slip and idle, try to open the empty machine to see if the motor is rotating forward and backward, and reverse the thread head.
3. Preheating. Prepare the raw materials, install the motor, start preheating, set the thermometer to about 350 degrees, the thermometer pointer reaches 350 degrees, automatically disengages and no longer heats up, wait for the temperature to turn inside, and the machine can be turned on both inside and outside to unload the material and discharge the rod.
4. When feeding, feed a small amount of material first, and then feed normally after the machine is running normally. The machine sound is stable, and the finished rods come out evenly. If the load is large, the sound is abnormal, and the semi-finished rods come out slowly or stop, it means that the hopper is blocked (there should be no bark or wood residue in the prepared material). Use a thin wooden stick to poke the feeding port slightly.

Qualifications and Honors

Hot Tags: charcoal powder rod making machine, China charcoal powder rod making machine manufacturers, suppliers, factory, Rdf Briquetting, making wood pellets line, Punching Briquette Machine, Wood Branch Chipper, RDF Briquette Machine, charcoal briquette maker