Products

Home Products Ring Die Wood Pellet Machine Details

Fully Automatic Biomass Ring Die Pellet Machine

Fully Automatic Biomass Ring Die Pellet Machine

Biomass ring die pellet machine can produce high quality pellet fuel.

Send Inquiry

Features

Products Description

Ring die pellet machine mold disassembly steps
1. Turn off the power of the ring die pellet machine and wait for the machine to cool down.
2. Remove the feed hopper and feed pipe, and remove the discharge port and sewage pipe.
3. Use a wrench or stick to tap the mold surface to clean the particles.
4. Loosen the screw of the top rotating rod of the mold with the adjustment screw and take out the top rotating rod.
5. Loosen the tension screws at the top and bottom of the mold by hand, and then remove the two lifting rings.
6. Spray lubricating oil evenly on the mating surface of the mold.
7. Use a crane or forklift to remove the mold from the machine.

Product Parameters

Model	Capacity	Power	Dimensions
MK-250	100-200kg/h	15kw	11204401060mm
MK-300	200-300kg/h	22kw	12805601220mm
MK-350	300-400kg/h	30kw	13006001250mm

Product Analysis

Precautions for maintenance of ring die pellet machine mold
1. Before disassembly, please make sure that the machine is completely stopped. It is strictly forbidden to operate it while it is running.
2. Regularly check whether the surface of the mold is worn or cracked. If any problems are found, replace it in time.
3. Before using the mold, clean the mating surface of the mold and apply lubricating oil.

4. When using the mold, please pay attention to controlling the feed amount and feed speed to avoid excessive impact on the mold surface.
5. It is recommended to use stainless steel molds to extend the service life.
In short, the disassembly of the ring die pellet machine mold requires caution, and proper care and maintenance are also very important. Only under the premise of correct use and maintenance of the mold can the long-term and efficient operation of the machine be ensured.