How to use the branch crusher
I. Preparation
1. Check whether the branch crusher is working properly and whether there are any abnormal sounds.
2. Clean the branch crusher and check whether the screws and fasteners on the equipment are loose.
3. Select suitable branches and put them into the branch crusher. It is recommended to choose branches with a diameter of less than 5 cm.
4. Prepare protective equipment, such as gloves, masks, etc.

| Model | MK06 | MK08 | MK06-18 | MK08-30 | MK08-40 |
| Drive System | PTO | PTO | Diesel Engine | Diesel Engine | Diesel Engine |
| (20-40HP) | (35-50HP) | (18HP) | (18HP) | (18HP) | |
| Max. Chipping Dia. | 6" | 8" | 6" | 8" | 8" |
| Chip Size | Thickness<6mm | ||||
| Rotation Angle of Outlet | 360 degree | ||||
| Mounting Type | 3-point hitch | Towable | |||
| Working Efficiency | 5-7m3/h | 8-15m3/h | 5-7m3/h | 8-12m3/h | 9-15m3/h |
| Weight (kg) | 340 | 450 | 600 | 700 | 850 |
II. Operation steps
1. Turn on the power and the branch crusher starts working.
2. Put the branches into the feed port and gradually increase the pressure.
3. After the branches are crushed into small pieces, they are discharged through the discharge port.
4. After waiting for the branch crusher to stop working, turn off the power and clean the equipment.
III. Precautions
1. Wear safety protection equipment during operation to avoid injury.
2. During operation, the stability of the branch crusher must be maintained to avoid collapse or shaking.
3. It is forbidden to put hair, sleeves, necklaces and other debris near the branch crusher.
4. Do not put wet branches into the branch crusher to avoid affecting the service life of the equipment.

