Electric Wood Pellet Maker

Wood chip pellet mill manufacturers recommend the correct use of biomass pellet mill operation: the biomass pellet mill mounting shaft under the fixed nut, install the mold. Please note that the film feeding direction is clockwise, not reversed. Screw on the fixing nut and fix the mold at the size 145mm from the biomass pellet machine.

Place the measuring tape of the mold unit on the upper part of the roll. If it is below, the biomass pellet machine will not operate. Adjust the position of the two rolls of the mold device so that the contact surface between the wood pellet machine and the rolls is at least about 180 degrees to 250 degrees. (It can be adjusted appropriately according to the actual situation to get enough conveying force).

Adjust the biomass pelletizer bracket so that its end face is perpendicular to the bottom plate of the machine. Adjust the biomass pelletizer so that its position is 145mm from the bottom plate.Adjust the pressure of the longitudinal heat sealing roller, transverse heat sealing roller and cooling roller. So that it can heat seal better.

Commercial wood pellet mill

Biomass pellet machine after the end of production, must be timely clean up the feeder, clean the machine and the environment, so as to make the next production operation smoother, even if there is a problem, it can be found and solved in time.
As long as the machine has easy to wear parts, especially biomass pellet machine, like pressure roller, triangular belt, modulator paddle, scraper, etc., should be checked, it is best to carry out a weekly inspection.
Every month you should check the position of the wear ring, and the clearance of the main bearing should be paid more attention to.
Biomass pellet mill is widely used in boiler plant, power plant, the raw material is very simple, like crops, furniture factory waste, green waste and so on.

Domestic wood pellet machine

1, often check the bolts and nuts of the equipment to prevent loosening. In addition, the tension of the transmission chain should be checked and adjusted frequently, if the chain is too loose, it should be adjusted in time.
2, biomass pellet mill equipment running, should always check whether the work of each part is normal, if there is any abnormality should immediately stop the car to check, remove before continuing to work.
3, the use of biomass pellet mill must be checked before the machine whether there is a problem, if there is a problem should immediately stop using, such as troubleshooting before use.
4, biomass pellet machine in operation is strictly prohibited to open the cover to check or clean the feed port and discharge port dust.
5, biomass pellet machine running process is strictly prohibited by hand to directly clean or twist the rotating parts of the belt, in order to prevent accidents.
6, wearing parts detection, like pressure rollers, molds, rolling skins and bearings, etc., should be checked, it is best to carry out a weekly inspection. Serious wear and tear in time to replace, so as not to affect the output.
7, biomass pellet mill after use, must be cleaned of all materials in the machine.

Hot Tags: electric wood pellet maker, China electric wood pellet maker manufacturers, suppliers, factory, carbonization stove, biomass pellet manufacturing plant, bagasse briquetting machine, biomass briquetting, Wood Chipper, pellet mill equipment