Electric Pellet Mill

When we use the biomass fuel pellet mill, we must maintain its motor, because the motor is the power to drive the equipment. Once damaged, the biomass fuel pellet mill equipment will not be able to run. The biomass pellet mill manufacturer warmly suggests that it is necessary to master some methods of maintaining the motor of the biomass fuel pellet mill.

The bearings of the biomass fuel pellet mill should be sorted and replaced in time after a period of use. The frequency of sorting and replacement should be determined according to the working time of the motor of the biomass fuel pellet machine. The general replacement frequency is to sort and replace the lubricating grease and mechanical oil after the motor of the biomass fuel pellet mill works for about half a year.

Check the coupling of the transmission part of the biomass fuel pellet mill machine for hard wounds and damaged couplings. Damaged couplings can create many dangers. Biomass pellet mill manufacturers suggest that it should be replaced in time can effectively avoid many accidents.Check the direction of some fixing screws of the biomass fuel pellet mill to see if they are loose. If they are loose, the work should be stopped and the staff should tighten them in time to avoid accidents.

Biomass pellet maker

Water flushing
Water rinsing is a simple, convenient, economical and effective cleaning method. The specific steps are as follows:
1. Remove the new ring mold and place it in a wide-mouthed stainless steel basin.
2. Rinse the new ring mold with water, wash the surface of the dust, oil and other impurities. At this time, the water can be added to the appropriate amount of cleaning agent to enhance the cleaning effect.
3. Repeatedly rinse the ring mold with the faucet to ensure that the holes are completely open, and the new ring mold will be washed and dried for spare.
Precautions:
1. When rinsing, pay attention to the water pressure should not be too large, so as not to damage the new ring mold.
2. The amount of cleaning agent used should not be too much, excessive use may cause damage to the ring mold.
Artificial cleaning
Artificial cleaning is a more cumbersome ring mold cleaning method, but the effect is better. The specific operation steps are as follows:
1. Remove the new ring mold, with a wire brush, gauze and other things will ring mold holes one by one to clean, but also to remove the surface of the oil, dirt and so on.
2. After cleaning, rinse with water repeatedly, and then dry the new ring mold for spare.
Precautions:
1. In the cleaning process, the strength of the wire brush should not be too large, so as not to brush the ring mold.
2. After cleaning, carefully check whether the holes are clean and smooth.

Fuel pellet machine

Chemical cleaning is a relatively complex and expensive ring mold cleaning method, usually applied to the production process in the presence of difficult to clean rust, dirt and so on. The specific operation steps are as follows:
1. Soak the new ring mold in the chemical cleaning solution, and remove the new ring mold after the chemical agent in the cleaning solution is fully impregnated to the surface of the ring mold.
2. Repeatedly rinse the new ring mold with water to remove the dirt on the surface of the ring mold and in the holes.
3. Use neutral solvent to degrease the new ring mold, and then dry it for spare.
Precautions:
1. The choice of chemical cleaning solution must be appropriate, the use of excessive or too concentrated chemical agent may cause damage to the new ring mold.
2. During the degreasing process, care should be taken to avoid over-soaking of the new ring mold, so as not to affect the service life of the new ring mold.

Hot Tags: electric pellet mill, China electric pellet mill manufacturers, suppliers, factory, biomass pellet press for transportation, pellet mill for wood pellet size control, biomass pellet press for capacity, biomass pellet press for size control, pto driven pellet mill, wood pellet forming quality control