How To Adjust The Fuel Pellet Machine?

                  Put the fixed nut down on the biomass pellet machine mounting shaft and install the mold. Please note that the film feeding direction is clockwise, not reverse. Screw on the fixing nut and fix the mold at the size 145mm from the biomass pellet machine. Place the measuring tape of the mold unit on the upper part of the roll. If it is below, the biomass pellet mill will not operate. Adjust the position of the two rolls of the mold unit so that the contact surface of the biomass pellet machine and the rolls are at least 180 degrees to about 250 degrees.

                  Adjust the position of the rolls so that the left cut point is perpendicular to the end face of the biomass pelletizer. The positioning height depends on the width of the raw material. The wider the feedstock, the higher the height and vice versa. The bottom plate of the biomass pellet mill is also vertical as can be seen from the left front. Adjust the biomass pelletizer stand so that its end faces are perpendicular to the machine's base plate. Adjust the biomass pelletizer so that it is positioned 145mm from the base plate.