Fuel Pellet Mill Influence Factors?

                     Material moisture is too low, the hardness of the processed product is too strong, and the power consumption of the sawdust pellet machine equipment during processing is large, which increases the production cost of the enterprise and reduces the service life of the sawdust pellet machine. Too much water, easy to be crushed, increasing the number of hammer impacts. At the same time, heat is generated due to the friction of the material and the strike of the hammer, which evaporates the water in the processed product. The evaporated water forms a paste with the crushed fines, clogging the sieve holes and reducing the discharge of the sawdust pellet mill. General rice husk stalks, corn stalks and other products raw material crushed product moisture control below 14%.

                     When the material crushing is about to end, mix a little wheat husk with edible oil and put it into the sawdust pellet machine machine. After 1-2 minutes of pressure, stop the machine so that the sawdust pellet machine mold holes filled with oil for the next start-up production, not only can maintain the mold, but also save time. After stopping the sawdust pellet machine, loosen the adjusting screw of the pressure wheel and remove the residual material.