How To Use The Fuel Pellet Machine?

                         Add gear oil first, and add heavy load gear oil according to the instructions. When the rice husk pellet machine is used for the second time, it must be crushed. The hole is astringent, need oil lubrication. The grinding material is configured in the ratio of 5:2. Mix the bran and sawdust with the waste engine oil and set aside. Adjust the pressure roller screw and adjust it evenly until the roller cannot be turned by hand. Turn on the Rice Husk Pelletizer and recheck the rotation of each of the press wheels. If the press wheels are not touching the disk, adjust the screws again until the rollers touch the disk, and then put the oil into the rice husk pelletizer one grain at a time.

                         After normal discharge, increase the input and then repeat the operation. Grind for half an hour and put into normal production. Do not discard the abrasive material, when it is expected to be unused for a long time after working, press the abrasive material into the machine so that it will not clog the holes next time it is used. The raw material should be mixed with water and stirred well before granulation. The proportion of raw material is controlled at 50%. The feeding method can be manual, screw conveyor or belt conveyor. After the granulator is finished, loosen the screws of the pressure roller to make the roller in a free state, and clean up the residual material after stopping the machine.