Knowledge

What precautions should be taken when using the Best electric wood pellet mill?

 

Home use pellet mill/wood pelletizer parameter adjustment notes

 

First, the core principle of parameter matching for a flat die wood pellet mill is to dynamically adjust parameters based on raw material characteristics and pellet state, aiming for "good pellet formation and stable equipment load." The key points for parameter matching differ depending on the raw material: For processing softwood chips (high lignin content, good viscosity), the temperature should be controlled at 75-85℃, the pressure at 10-12MPa, and the feed rate can be slightly faster (close to rated capacity); for processing hardwood chips (high hardness, poor viscosity), the temperature needs to be increased to 90-105℃, the pressure at 13-15MPa, and the feed rate reduced by 10%-20% to allow the raw material to be fully heated and softened in the pressing chamber. For example, when processing oak chips, a temperature below 90℃ will result in loose pellets; increasing the temperature to 98℃ significantly improves the pellet formation rate.

 

For raw materials with different moisture content, the parameters of the small flat die wood pellet making machine must be precisely adjusted. For processing dry raw materials (moisture content 12%-14%), the basic parameters can be set. For processing slightly damp raw materials (after pretreatment), a combination of "speed reduction, temperature increase, and pressure increase" is required: reduce the feed speed by 30%-40% to prevent material accumulation and sticking; increase the temperature by 5-10℃ to help the moisture evaporate quickly and enhance the viscosity of the raw material; increase the pressure by 5%-10% to ensure that the pellets are fully extruded and formed. During trial operation, pay attention to current changes. If the current exceeds the rated value, it indicates that the pressure increase is too large and needs to be adjusted appropriately. If the raw material has a high moisture content (without pretreatment), do not force the parameters to be adjusted for processing; it must be dried first, otherwise it will cause serious equipment blockage.

 

Home Use Pellet Mill Wood PelletizerHay Pellet MachineMultifunctional Biomass Sawdust Pellet Machine

 

The parameters of the Flat Die wood pelletizer mill should also be flexibly adjusted according to different production capacity requirements. For low-capacity production (below 50% of rated capacity), appropriately reduce the feed rate and pressure, and maintain the temperature at the baseline value to avoid idling and causing dry grinding of components. For full-load production (rated capacity), ensure proper pretreatment of raw materials, set the temperature and pressure to the upper limit, and closely monitor the equipment's operating status. Check the pellet quality and motor temperature every 30 minutes to avoid overload leading to malfunctions. Overload production is absolutely prohibited, as it will cause the motor and transmission system to be in a state of fatigue for a long time, significantly shortening the equipment's lifespan.

 

Practical tips for adjusting parameters of a flat die wood pellet making machine: Do not make large adjustments each time. Adjust the temperature by ±5℃, pressure by ±0.5MPa, and feed rate by ±5% each time. After adjustment, test process for 10-15 minutes, observe the pellet appearance (smoothness, cracks) and equipment current, and then decide whether to continue adjusting. It is recommended to record the optimal parameters for different raw materials and humidity levels to create a parameter manual for direct reference during subsequent processing, reducing trial and error costs.

 

about us

Customer visit

20240314111731

Certificate of Honor

 

Certificate of Honor

 

FAQ

 

1.What is the price of equipment for the Flat Die Pellet Machine?

It costs approximately US$1,500.00 - 25,000.00

 

2. If equipments have some quality problem, how would you deal with?
We will responsible for all the quality problems. Change all the parts for free.

 

Contact now

You Might Also Like

Send Inquiry