The solution to the non discharge of biomass compactor
With the coordinated governance of energy and environment in our country, people are increasingly pursuing fuel that saves energy and protects the environment. Biomass pellet fuel is an ideal fuel to replace kerosene, which can not only save energy but also reduce smoke and dust emissions, as well as achieve economic and social benefits. It is an efficient and clean renewable energy source. In many factories and enterprises, biomass pellet machines are used to process and manufacture biomass pellets from company waste such as wood chips, straw, rice husks, bark, etc. This not only protects the environment but also saves a lot of costs. However, biomass briquetting machines often encounter situations where the material cannot be discharged during use. It is necessary to stop the machine in a timely manner to check the cause and avoid equipment damage.
1. Excessive feeding speed:
The biomass compactor requires a uniform feeding speed and a feeding amount that matches the rated capacity of the equipment. Uneven feeding speed or excessive feeding volume can lead to blockage of the feeding port. If the feeding machine is not stopped in a timely manner, will it cause it? The biomass briquetting machine is used for soaking. After confirming that the feeding is too fast and the material is not discharged, first stop the feeding belt. Be careful not to stop the biomass compactor, because once the biomass compactor is stopped, the material in the granulation chamber may be full, which may cause you to be unable to start the machine. Therefore, just stop the feeding belt machine. Then take the formed compression block particles, slowly add them inside, observe the discharge situation, and gradually increase the feeding amount of the formed particles after discharge. After waiting for the mold to be fully opened, turn on the belt conveyor and adjust the feeding amount to continue production. If this method is not effective, the machine can only be stopped, the grinding tool removed, and the hole inserted. But be careful not to let the machine move on its own, as it can damage the machine.
2. There is accumulated material inside the biomass pellet machine:
If the accumulated material is not discharged in a timely manner after the production is completed, due to the high temperature and large steam volume during the production process of the particle machine, these accumulated materials will harden and clump, and the next time the wood chip particle machine is started for production, it will be unable to discharge the material normally. If this situation occurs, turn on the biomass compactor after shutting down, remove the accumulated material inside, and then start normal production to discharge the material. It is important to note that at the end of each production, the accumulated material in the briquetting machine must be completely discharged to avoid causing abnormal production in the next production. Before stopping the machine, be sure to use oil to replace the sawdust particles in the mold holes, in order to avoid not discharging the material in the next production.
3. The material is too wet with moisture.
The reason why the biomass compactor starts discharging is because at the beginning, the material mold is ground by oil, and the temperature of the mold pressing rod rises. Wet materials begin to enter the granulation chamber. Due to the friction of the rod mold, it plays a certain role in squeezing, friction, and drying the material. However, as the feeding amount continues to increase, the evaporation of this small amount of water becomes insignificant, resulting in sawdust cake in the granulation chamber, which blocks the mold hole and prevents discharge. Since this situation indicates that the moisture content of the material is close to 20%, it can be slightly dried or a small dryer can be used.

