How to assemble the fuel pellet machine?
When our biomass fuel pellet mill has problems, how should we deal with it? This is a question that our customers are very concerned about, because if we don't pay attention, a small part may destroy our equipment. Therefore, we must pay attention to the maintenance of the equipment as well as repair, so that we can make our pellet machine normal or even realize the overload operation without problems.
1, generally do not need to dismantle the feed cover, only need to open the observation window on the pelletizing chamber to check the working condition of the pressure wheel.
2, if you need to replace the pressure wheel or replace the mold, you need to remove the feed cover and the pressure wheel bin to unscrew the above screws and nuts, and then unscrew the lock nut on the spindle, the pressure wheel assembly with a sling to lift the whole lifted out of the pressure wheel bin, and then two lifting screws screwed to the die plate on the process holes, with a sling to lift it, and then use the other side of the mold reversed.

| Model | Capacity | Power | Dimensions | Weight |
| MK-250 | 100-200kg/h | 15kw | 1120*440*1060mm | 400kg |
| MK-300 | 200-300kg/h | 22kw | 1280*560*1220mm | 700kg |
| MK-350 | 300-400kg/h | 30kw | 1300*600*1250mm | 800kg |
| MK-400 | 400-600kg/h | 37kw | 1390*650*1290mm | 1000kg |
| MK450 | 600-800kg/h | 45kw | 1620*700*1600mm | 1500kg |
3, if the pressure wheel skin or pressure wheel bearings need to be replaced, you need to remove the outer sealing cover on the pressure wheel, remove the round nut on the pressure wheel shaft, and then drive the pressure wheel bearings out from the inside to the outside, bearings need to be replaced or not after removal (cleaned with diesel fuel), the inner hole of the pressure wheel should be kept clean, and then the pressure wheel assembly can be installed according to the reverse order.
Biomass fuel pellet mill is now more and more widely used because of its unique characteristics, in the use of the pellet mill to guard against the emergence of some common problems, so as to make the pellet mill work more efficiently at the same time can also extend the service life.
Biomass fuel pellet mill use attention to the following problems:
1, do not add too much raw material in the initial operation stage of the pellet machine, in the break-in period, the new machine output is generally lower than the rated output, but after the break-in period, the output will reach the rated output of the machinery itself.
2, biomass pellet machine smooth and cooling process, the pellet machine pressure roller to squeeze the wood chips and other materials into the mold holes, and push the reverse side of the raw material to the front of the raw material, the pellet machine pressure roller directly affects the molding of the particles.

