Bbq Charcoal Making Machine

Reasons why Agro waste briquetting machine does not discharge material:
1. The first thing is to check the wiring problem. Check to see if the wiring on the device has fallen off or become loose during transportation. Another is to check whether the wiring is reversed and whether the motor is rotating forward. After these are done, start the second step.
2. Check the dry humidity of the raw material. If the humidity of the raw material is high, it is easy to not produce the rod. The temperature of the raw material must be increased. If the heating temperature is too low, the charcoal rod will not come out easily. Then check the power supply. If the power supply is too low, this problem will also occur.
3. If the carbon rod is not formed or is slow, then you need to check whether the temperature is too high, or the thermocouple is installed in the wrong position, and the angle of the thermocouple needs to be adjusted. Also, if the grease in the raw material is too large, the carbon rod will not be formed.

Biomass brick machine

Automatic biomass briquetting machine raw material analysis:
The main raw materials of carbon rods are activated carbon and resin. Activated carbon is a loose and porous carbonaceous material with strong adsorption capacity. The usual preparation methods include physical adsorption, chemical adsorption and physical chemistry. Resin is a polymer material primarily used to bind and secure activated carbon particles. Before production, these two raw materials need to be screened, ground and finely processed to ensure the purity and uniformity of the raw materials.

Biomass brick press finished product display:

Biofuel briquette machine process:
1. Crushing procedure. Large pieces of raw material need to be crushed into chips of about 5mm to lay a good foundation for later rod forming;
2. Drying process. Put the crushed chips into a dryer for drying, so that the moisture content of the material reaches about 5-10%, so that good hollow wooden rods can be made during the extrusion rod forming process.
3. Rod forming process. The crushed and dried raw materials are put into the rod making machine and extruded under high temperature and high pressure to make a good machine-made hollow wooden rod. The three steps of crushing, drying and rod making are indispensable and very important. Later firing will serve as the foundation.
4. Carbonization process. After the firewood sticks are made, they are carbonized in a carbonization furnace. After cooling, they become machine-made charcoal.

Our team

Packing and shipping

Hot Tags: bbq charcoal making machine, China bbq charcoal making machine manufacturers, suppliers, factory, lump fuel equipment, mulcher chipper, cotton stalk briquette making machine, industrial chipper, industrial wood shredder, Coconut Shell Briquette Machine