Fuel Pellet Maker

The output of the wood pellet mill is too low, or even no pellets are produced, or a lot of powder is produced. Although this problem doesn't occur very often, if it does, it means that you didn't polish the press wheel and the grinding disk well during the grinding process of the rice husk pellet mill pellets.

A similar problem can occur because the grinding holes in the grinding disk were not well polished when you first started using the rice husk pellet mill. After the discs have been ground with abrasives or after a period of time, the rice husk pellet mill will reach its normal output.

The clearance between the press wheel and the grinding disk of the wood pellet machine is too large, which may also be one of the reasons why the rice husk pellet machine does not discharge material. The method of adjusting the gap between the press wheel and the grinding disk of the rice husk pellet machine is to tighten the press wheel with one hand and adjust the corresponding bolts until the press wheels on both sides can not be shaken with force and are slightly tightened, that is, it means that the press wheel and the grinding disk of the rice husk pellet machine have been adjusted in place.

Hardwood pellet mill

1, when the biomass burner supporting thermal equipment system is running normally, according to the heat load in time to increase or reduce the biomass pellet fuel feeding rate, while timely observation of the wind size is matched, and always observe the chimney exhaust, to the chimney without soot emissions for the best.
2, from time to time to observe the water temperature gauge and pressure gauge of the burner, timely detection of changes in water temperature, adjust the amount of drainage to ensure that the water temperature is less than 100 degrees, the pressure gauge does not produce water vapor, to ensure that the biomass pellet combustion machine to ensure the safe operation of the operation of the water shortage to prevent the emergence of the operation of the water shortage.
3, according to the biomass pellet combustion machine hopper pellet fuel consumption, timely and regularly add fuel appropriately to ensure that the biomass pellet fuel supplied to the furnace chamber in a timely manner, so as to avoid the emergence of a lack of material operation caused by the lack of heat output.
4,According to the change of energy consumption within the thermal energy equipment, adjust the amount of intermittent feeding of small and large fire stages in a timely manner.
5,When the burner is burning normally, it is strictly forbidden to open the slag door at will.

Flat die pellet mill

The use of the pellet machine is relatively simple, but it must also be used correctly
1,First of all, check whether the screws of each part are tight or not.
2,Before starting the machine, loosen the two adjusting screws on both ends of the pressure wheel, then start the motor and observe whether the machine rotates with the same knowledge.
3, the first two pressure wheel adjusting screws tighten, boot, and then successively feeding grinding, repeated grinding several times, to achieve the template hole smooth all the material until.
4, granule machine stop feeding before stopping, to be bin material processing is completed, plus soil containing oil pressed into the template hole, keep the hole lubrication, in order to prepare for the next use will not occur blocking phenomenon.

Hot Tags: fuel pellet maker, China fuel pellet maker manufacturers, suppliers, factory, Coconut Shell Charcoal Making Machine, hookah charcoal making machine, tree shredder machine, Biomass briquette press machine, punching briquette press, Fire Wood Briquette Making Machine