Commercial Wood Pellet Maker

Prevent blockages in the sawdust particle forming machine: It is recommended that the gap between each drum and the mold is not too complex. Suggest adjusting the gap between each drum and the mold.

Too big gap will affect the production efficiency of wood pellet mill, even can't press out the pellets. If the gap is too small, it will accelerate the wear between the pressure rollers and reduce the service life of the mold.

If the machine is blocked, you need to loosen the pressure roller, remove the material, and then adjust the die roller gap from the beginning to prevent damage to the transmission part and bearing gears due to violent oscillation.In addition, the tightening of fasteners in all parts should be checked in a timely manner. If there is any looseness, it should be tightened in time.

Wood pellet equipment

1. Turn on the power of the pelletizer and wait for the equipment to warm up for 5-10 minutes before pelletizing.
2. Place the material to be granulated evenly in the hopper, turn on the vibration switch to make the material pass through the hopper and enter the pelletizer automatically.
3. Adjust the rotating speed and pressure of the pelletizer so that it can carry out pelletizing process under appropriate temperature and pressure.
4. after the pelletizing is completed, turn off the power and wait for the equipment to cool down and clean the material residue attached to the equipment.

1. regularly check whether the wires and electrical components of the pelletizer equipment are in good condition, and replace them in time if they are broken or aged.
2. regularly clean the internal and external surfaces of the pellet mill equipment to avoid material and dirt accumulation leading to equipment failure.
3. lubricate the parts of the pellet mill equipment frequently to reduce the friction during operation and prolong the life of the equipment.

Machine that makes wood pellets

First, start the machine:
Biomass fuel pellet machine in use, just start the machine, first do not feed, to let the equipment first run for three minutes, but recognize that the machine is running normally, and then evenly feed.
Two, raw materials:
The screening of raw materials should be in place, the raw material should not contain, iron, stone and other impurities, if it contains such things, the machine will wear out very seriously, or even damaged.
Three, hopper.
When the machine is turned on, do not remove the hopper, so as not to hurt the material flying out. This is not worth the loss.
Four, other.
Site is also necessary to remind, our workplace, to spacious, ventilated, and equipped with fire prevention facilities. Do not smoke and play with fire when working.
There are many raw materials that can be pressed by the biomass pellet mill, such as grass, wood, feces, fabric and so on.

Hot Tags: commercial wood pellet maker, China commercial wood pellet maker manufacturers, suppliers, factory, Sawdust Briquette Molding Machine, portable wood pellet machine, coal dust briquetting machine, Charcoal briquette cutter, straw pellet mill, charcoal coal big pellet making machine