What are the problems sometimes encountered by the fuel pellet machine?

              Straw pellet machine does not stick: the heating temperature is too high or too low, the molding sleeve is badly worn, the propeller angle does not match, the raw material is too much water. Forming machine normal work forming rod from the sleeve uniform extrusion, the rod should be dark brown, uniform hardness, smooth surface, no cracks, the surface of the center hole is also smooth, smooth exhaust.

             Straw pellet machine "cannon" may be due to the following reasons: improper temperature control, raw material moisture is too large, wear and tear of the propeller, the shaft tip is not correct, the exhaust holes are clogged, the propeller head screw is too large or too small, the sleeve is severely worn, etc... Encountered this situation should be according to the above reasons one by one control, find out the reasons for the corresponding adjustment. "Stuffy car": the raw materials are mixed into the larger particles and hard impurities. Low voltage or low heating temperature, may also be the raw material is not dry, the former need to stop and disassemble, remove impurities. The latter to continue to soften the raw material heating, or re-drying.