Precautions for disassembly and assembly of biomass fuel pellet machine
1. Generally, there is no need to remove the feed cover, just open the observation window on the pelletizing chamber to check the working condition of the pressure wheel.
2. If you need to replace the pressure wheel or replace the mold, you need to remove the feed cover and the pressure wheel bin, unscrew the screws and nuts on it, and then unscrew the locking nut on the main shaft, lift the pressure wheel assembly with a lifting belt and move it out of the pressure wheel bin, and then screw two lifting screws to the process holes on the mold plate, lift it with a lifting belt, and then turn the other side of the mold over for use.
3. If the roller skin or roller bearing needs to be replaced, the outer sealing cover on the roller needs to be removed, the round nut on the roller shaft needs to be removed, and then the roller bearing needs to be driven out from the inside to the outside. After the bearing is removed, it needs to be replaced or not (cleaned with diesel), the inner hole of the roller needs to be kept clean, and then the roller assembly can be installed in reverse order.

| Model | Capacity | Power | Dimensions | Weight |
| MK-250 | 100-200kg/h | 15kw | 1120*440*1060mm | 400kg |
| MK-300 | 200-300kg/h | 22kw | 1280*560*1220mm | 700kg |
| MK-350 | 300-400kg/h | 30kw | 1300*600*1250mm | 800kg |
| MK-400 | 400-600kg/h | 37kw | 1390*650*1290mm | 1000kg |
| MK450 | 600-800kg/h | 45kw | 1620*700*1600mm | 1500kg |
Pay attention to the following issues when using the biomass fuel pellet machine:
1. Do not add too much raw material in the initial operation stage of the pellet machine. During the running-in period, the output of the new machine is generally lower than the rated output, but after the running-in period, the output will reach the rated output of the machine itself.
2. Pay special attention to the analysis when grinding the pellet machine. The pellet machine needs to be run-in before it is purchased and operated. Before formal use, reasonable grinding has a very important impact on the later use of the pellet machine. The ring die roller of the fuel pellet machine is a heat-treated part. During the heat treatment process, there are some burrs in the inner hole of the ring die. These burrs will hinder the flow and forming of materials during the operation of the pellet machine. It is strictly forbidden to add hard debris into the feeding device to avoid damaging the mold and affecting the production efficiency and life of the pellet machine.

