Straw Pellet Mill

Rice husk pellet making machine
Even if customers buy biomass fuel pellet machines to make money, they can't make money if the molding is not good. So why is the pellet molding not good? This problem has troubled many people in biomass pellet factories. The following editor will explain it from the perspective of the types of raw materials. Next, let's learn about it together!
The compression molding performance of various types of raw materials varies greatly. The type of material not only affects the molding quality, such as the density, strength, calorific value of wood chip pellets, but also affects the output and power consumption of the biomass fuel pellet machine.

Straw pellet press

Stove pellet maker
Among many agricultural and forestry wastes, some crushed plants are easy to be pressed into pellets, while others are more difficult. Wood chips themselves contain a lot of lignin, which can be bonded at a high temperature of 80 degrees, so there is no need to add adhesives to form wood chips.
The particle size of the material is also an important factor affecting the forming. For a certain forming method, the particle size of the material cannot be greater than a certain particle size.
The biomass fuel pellet machine is a device used to grind wet powder into the required pellets, and can also crush block dry materials into the required pellets. The main features are that the screen is easy to install and disassemble, and the tightness can be adjusted appropriately, and it is easy to disassemble and clean.

Wood chip pellet maker

Straw pellet mill
Once a month, check whether the worm gear, worm, bolts on the lubricating block, bearings and other active parts are flexible and worn. If defects are found, they should be repaired in time and should not be used reluctantly.
After the biomass fuel pellet machine is used or stopped, the rotating drum should be taken out for cleaning and brushing the remaining powder in the bucket, and then installed properly to prepare for the next use.
When the drum moves back and forth during work, please adjust the M10 screw on the front bearing to the appropriate position. If the gear shaft moves, please adjust the M10 screw behind the bearing frame to the appropriate position, adjust the gap so that the bearing does not make noise, turn the pulley by hand, and tighten it appropriately. Too tight or too loose may cause damage to the machine.

Qualifications and Honors

Hot Tags: straw pellet mill, China straw pellet mill manufacturers, suppliers, factory, log shredder, home wood pellet mill, Wood stick carbonization equipment, Fully automatic briquetting machine, charcoal-producing furnace, Biomass Pellet Line