Corinth Pellet Mill

In the current situation of increasingly serious environmental pollution, straw pellet mill gradually came into people's vision. As a less polluting solid biomass fuel molding equipment, it has been highly evaluated by many customers.

In the past, the raw materials were generally processed into powder, which had such defects as inconvenient transportation and low utilization rate. With the introduction and popularization of new small straw pellet machinery, it is now possible to conveniently process powdered raw materials into biomass fuel pellets.

Lighting power can be used as a driving force, under the extrusion of the pressure roller from the mold hole in the granulation, you can easily adjust the length of the particles, its structure is simple, small footprint, low noise, 220 volts of single-phase electricity can be operated for the lack of three-phase power conditions of the use of small-scale users.

Homemade wood pellet machine

1, Before starting the burner, clean the carbon of the furnace bridge, clean the carbon of the furnace bottom, add pellet fuel, close the lid of the material tank, open the spacer valve;
2, Turn on the power to use the equipment, manufacturing biofuel, check whether the circuit, water pipe is normal, check whether the cooling pool is enough water. Open the burner cooling water in and out of the water valve, and confirm that the high temperature combustion chamber sandwich cooling water filled;
3, the air supply gear to a smaller, put the right amount of primer, the official ignition start, biofuel manufacturing, light open the door to the appropriate air supply, close the door, start the feeding system, and gradually increase the air supply gear to the right amount. Feeding speed and air volume should be gradually increased, should not be accelerated too quickly, there should be 2-3 minutes, so that the normal rise in furnace temperature.
 

Domestic wood pellet machine

1, feeding speed to 30-80 for the conventional dosage, fast not more than 100 speed, slow not less than 20 running, air configuration for the median; production line heat transfer system in the case of good ventilation feeding speed can be appropriately accelerated, the wind can be equipped with a stall, but should always observe the chimney exhaust situation to determine the standard of feeding speed without soot emissions;
2, Observe the change of water temperature from time to time and adjust the drainage volume, so as to be safe and economical;
3, according to the user's raw material consumption law appropriate to add fuel, to ensure the normal operation of the equipment;
4, according to the changes in product energy consumption to adjust the insulation stage of the intermittent feeding volume;
5, It is forbidden to open the upper and lower furnace doors when the furnace is burning.

Hot Tags: corinth pellet mill, China corinth pellet mill manufacturers, suppliers, factory, wood pellet press machine, homemade wood pellet machine, Biofuel Briquette Press Machine, wood chip pellet machine, pellet stove pellet mill, fuel pellet making machine