What Are The Operating Skills Of RDF Briquetting Machine?

When using the biomass briquette extruder, a small amount of material should be fed evenly. First, add materials with a moisture content of >40% until all die holes of the equipment are discharged. At this time, the pressure, temperature and other parameters of the equipment are in normal conditions. Discharging takes 10 minutes. Then add materials with <20% moisture content until the material is discharged normally. The moisture content of raw materials during the production process must be controlled within 20%. If the moisture content is too high, the molding density will be low, so the feeding speed should be reduced and the residence time should be extended; when the raw material is too dry, water should be added appropriately for lubrication. During the production process, avoid frequent starts or overload operation. When there is a sudden power outage or overload, the machine should be stopped immediately, the raw materials in the machine warehouse should be cleaned, and it can only be started after everything is normal.

When the wood dust briquetting machine is shut down, there are also things to pay attention to. Prepare wet materials with a moisture content of about 50%. According to the discharge of bulk materials, increase the amount from small to large until all the die holes have discharged bulk materials. Stop feeding and then proceed in sequence. downtime. When shutting down, the machine must wait until the materials are completely unloaded before it can be shut down. It must not be shut down when it is fully loaded. After shutdown, check and clean up remaining materials, and clean the equipment and surrounding environment. The finished materials should be moisture-proof and waterproof, and the storage area must be ventilated and dry.