How To Use The Wood Chip Pellet Machine Correctly?

               The wood chip pellet machine manufacturer reminds the operator that if there is vibration, noise, high temperature of bearing and body, spraying outward, etc., the machine should be shut down immediately for checking, and continue to work after eliminating the trouble.
               Prevent the blockage of wood chip pellet machine:It is recommended that the gap between each roller is not too complicated, and it is recommended to adjust the gap between each roller and the mold. A certain gap should be maintained between the pressure rollers of the straw pellet machine, with 0.1-0.3mm as appropriate. If the straw is pressed, it can be increased to 0.8mm. gap adjustment is important. Too large a gap will affect the productivity of the straw pellet machine, and even can not press out the particles. If the gap is too small, it will accelerate the wear between the pressure rollers and reduce the service life of the mold. In case of blockage, it is necessary to loosen the pressure roller, and then adjust the die roller gap from the beginning to prevent damage to the transmission part and bearing gear due to violent oscillation. In addition, the fasteners of each part should be checked in time. If there is any loosening, it should be tightened in time.