Knowledge

What should I do if the fuel pellet machine is used abnormally?

                      If we find these problems, we need to replace or repair the ring die and cone hole. In addition, the gap between the ring die and the pressure roller should always be adjusted correctly. Generally when producing biomass fuel pellet mill, the gap between the ring mold and the pressure roller should be about 5-8cm. If the gap is too small, the friction between the pressure roller and the ring die will shorten the service life of the ring die. If the gap is too large, the pressure roller will slip and reduce the output.

                    The time and quality of the raw material conditioning of the biomass fuel pellet mill are important, especially the moisture content of the raw material. The moisture content of the raw material before conditioning is generally 13%. If the moisture content is too high (moisture ≥ 16%), the mold will slip, and it is not easy to discharge the material. Fineness of raw materials. The fineness of the raw material when crushed with a pulverizer should match the diameter of the mold hole. At the same time to ensure the quality and temperature of steam. If the steam quality is poor and the tempering temperature is low, it will affect the curing effect of the powder and reduce the output.

small wood pellet machine

You Might Also Like

Send Inquiry