How to use the fuel pellet machine?

                      After the biomass corn stover fuel pelletizer is installed, check the tightness of all fasteners, tighten them if they are loose. Check whether the transmission belt is suitable for loosening and tightening, and whether the motor shaft is parallel to the corn stover fuel pelletizer shaft. Biomass pellet mill manufacturers suggest that before the biomass corn straw fuel pelletizer runs, rotate the motor rotor by hand, check whether the tooth claw, hammer head and motor rotor are flexible and reliable, whether there is any collision of the shell, whether the direction of rotation of the motor rotor is the same as that shown by the arrows on the corn straw fuel pelletizer, and whether the motor and the lubrication of the corn straw fuel pelletizer are good.

                    There is no need to change the pulley arbitrarily to prevent the high speed from causing the explosion of the crushing chamber or the low speed from affecting the working efficiency. After running the corn stover pelletizer, it should idle for 2-3 minutes before feeding. Pay attention to the running status of the biomass corn stover fuel pelletizer in time during the work. Feeding should be symmetrical to prevent prolonged blockage and overloading operation. If there are vibration, noise, bearing and corn stover fuel pelletizer body temperature is too high, spraying outward, etc., it should be shut down first to check and continue to work after troubleshooting.