Tanzanian Customers Visit To Learn About Fuel Pellet Machine Equipment

On May 20, 2024, a Tanzanian customer came to visit our company. Before that, the customer had consulted us online and expressed that he was very interested in our products. However, it was only an online communication, and the customer still had doubts about us. Regarding this , we express our understanding very much, and we sincerely invite customers to visit. We carefully summarize the matters that customers are worried about and come up with solutions. After the customers visit, we give a lot of explanations to them. , and we recommended the most reasonable solution to the customer's actual situation, and in response to the customer's questions, we made the following answers:

1. For the maintenance of the biomass pellet machine, when replacing raw materials every day; at the end of production, clean the magnet in the feed port, clean the rotor of the blocking sensor, check the degree of dirt of the temperature sensor, check the degree of the air suction device, and clean it in time Machines and environment.
2. After the biomass pellet machine has been working for a few days: Check the adjustment and wear of the pressure roller once a week. Once a month, check the tension of the V-belt, check the wear of the blades in the conditioner, adjust the wear of the scraper and blades, and check the wear of the scraper.
3. Check the position of the ring die in the wear ring every month, check the main bearing clearance once every quarter, check the pressure roller bearing clearance when adjusting the pressure wheel after each die change, and check the pressure roller frame spindle when disassembling the pressure roller. Bearings on the machine, check the isolation ring when disassembling the main bearing, check the emergency bearing sleeve in the frame, biomass pellet pellet machine is widely used in large, medium and small boiler plants and power plants; coarse fiber pelletizing, such as sawdust, rice husk , cotton stalks, cotton seed hulls, weeds and other crop straws, domestic garbage, factory waste, materials with low adhesion rate and difficult to form.