How To Replace The Mold Of The Biomass Pellet Machine?
Wrench
Pneumatic tool
Grease
New mold
II. Disassembly and dissection
1. Turn off the power of the biomass pellet machine to ensure that the equipment is in a safe state.
2. Use a wrench to remove the pressure wheel and remove the nut below the pressure wheel.
3. Use a wrench to remove the baffle and remove the fixing nut of the baffle.
4. Use a pneumatic tool to remove the section panel to expose the mold inside the machine.
5. Use a wrench and a wrench to remove the mold.
6. Remove the pressure wheel, clean the oil and loose parts on the pressure wheel, and apply new grease.
| Model | Capacity | Power | Dimensions |
| MK-250 | 100-200kg/h | 15kw | 1120*440*1060mm |
| MK-300 | 200-300kg/h | 22kw | 1280*560*1220mm |
| MK-350 | 300-400kg/h | 30kw | 1300*600*1250mm |
| MK-400 | 400-600kg/h | 37kw | 1390*650*1290mm |
| MK450 | 600-800kg/h | 45kw | 1620*700*1600mm |
III. Replace the mold
1. Install the new mold into the inside of the biomass pellet machine, and pay attention to the direction and position of the mold.
2. Apply new grease on the pressure wheel and reinstall it into the inside of the biomass pellet machine.
3. Reinstall the baffle fixing nut and the nut below the pressure wheel.
IV. Installation and assembly
1. Use pneumatic tools to reinstall the cut-out panel on the biomass pellet machine.
2. Assemble the above steps in reverse order to ensure that each component is firm.
3. Turn on the power of the biomass pellet machine and check whether the equipment is operating normally.
Through the above steps, the mold replacement of the biomass pellet machine is completed. Note that you need to be careful when replacing the mold to ensure that each step is correct to avoid equipment damage and personal injury.
