How To Avoid Clogging Of The Pellet Machine?

                    The solution to the clogging of the fuel pellet machine is: every time before starting the machine, take some sawdust that will be pressed into pellets and mix it with about 10% industrial oil. Ordinary engine oil will do. Crush the small pieces of the material, mix them thoroughly, put them into the wood pellet machine, turn on the machine to press the pellets, then put the pressed pellets back into the wood pellet machine, repeat 5-6 times, and then put in normal wood chips, that is Can be granulated normally.

                    On the other hand, if the moisture content of the wood pellet machine is too low, it will also cause no material discharge. Because if the wood pellet machine loses water, it will be difficult to be extruded. Generally speaking, the ideal humidity for granulation is 15%-22%. The granulation effect is best between this humidity. If the humidity of the raw material is too low, the solution is very simple, just spray some water. It is also possible that the mold of the wood pellet machine is seriously damaged.