Notes on the installation of the Biomass Pellet Machine!

                    Biomass Pellet Machine is not like a simple straw crusher, casually installed to achieve the crushing and processing operations, pellet machine in the installation of remember to be sure to operate according to the manufacturer's instructions provided, slightly incorrect, there are a lot of inconvenience to the processing operations in the later stage, the detailed installation steps are as follows:

                    Install the used ring die, must check the wear of the ring die in the direction of the width of the ring die, and if necessary, use it in the opposite direction; before installing the biomass pellet machine, the internal support surface of the pellet machine must be carefully cleaned and coated with a thin layer of molybdenum disulphide paste; install the pin on the ring die seat, and then hammer the ring die into the ring die with a hammer by aligning the pin holes of the ring die with the pin (when using the hammer, there must be a cushion of wood between the hammer and the ring die); install the 8 high strength bolts and spacers, and gradually tighten the screws, high strength bolts . I hope that you will pay attention to!