How to operate the wood chip pellet machine?

             The wood pellet machine can be formally granulated after washing the mold and washing the rollers, firstly, close the switching door, then dump into the hopper, and then start the machine. After starting the machine, first open the discharge port outside the machine, reversing to exhaust the original miscellaneous materials in the machine, to be miscellaneous materials exhaust, you can switch the hopper material into the machine.

             Beginning of granulation due to the temperature, pressure is not enough, should be preceded by a small amount of feed, that is, the switching door screws loose, with a good hand to grasp the switching door, so that the feed with the extension of the working time of the pellet machine, the temperature, the pressure of the rise and gradually increase. The beginning of the material out of the hole is not necessarily molded, should be re-poured into the hopper. When the switching door has been opened to a relatively large, mold hole out of the material particle hardness is normal, then you should pay attention to observe: in case of motor current rises suddenly, ringing sound strange or mold hole particles bursting, coking, you should immediately shut down, shut down the switching door, reversing to exhaust all the material in the machine, re-operation, until the normal work.