Biomass pellet machine operation guide?
Biomass pellet machine is a device that processes biomass energy raw materials into pelletized fuel. Its basic principle is to extrude the biomass raw materials through the die orifice under the pressure and friction in the pellet machine.
Operation process of biomass pellet machine
1. Raw material selection: Select biomass raw materials with a certain density and water content, such as straw, sawdust, etc.
2. Equipment installation and commissioning: Install the biomass pellet machine according to the instructions, and commission each component to ensure normal operation.
3. Operation skills:
(1) Control the feed speed to avoid equipment blockage due to too fast or too slow feed.
(2) Add lubricating oil regularly to ensure normal operation of the equipment.
(3) The particle size should be adjusted according to specific needs to avoid waste and poor production quality.
(4) When the biomass pellet machine has an abnormal situation, the equipment needs to be stopped immediately for inspection.
| Model No. | Capacity(kg/h) | Power(kw) | Weight(t) |
| RKL-250 | 100-200 | 15 | 0.5 |
| RKL-300 | 150-250 | 22 | 0.65 |
| RKL-350 | 100-300 | 30 | 0.76 |
| RKL-400 | 300-600 | 37 | 2.2 |
| RKL-450 | 500-800 | 55 | 4.3 |
| RKL-550 | 1000-1500 | 90 | 5.5 |
4. Make pellet fuel: Feed the processed biomass raw materials into the biomass pellet machine and extrude them through the die orifice.
Common Problem Solutions
1. What should I do if the equipment is blocked? Stop the equipment in time, disassemble and clean it, and check whether it is caused by too large raw materials or too high water content.
2. What should I do if the pellet fuel is too loose? Increase the pressure and adjust the die orifice to avoid hollowness.
3. What should I do if the particle size of the pellet fuel is different? Adjust the die orifice and the time the raw materials pass through to ensure uniform particle size.
4. What should I do if the equipment makes abnormal noises? Stop the equipment in time for inspection and check whether the equipment bearings and gears are normal.
