Troubleshooting Of Rdf Fuel Equipment!

                   The raw materials of the rdf fuel briquetting equipment must not be mixed with soil, sand, stones, metals and other substances to ensure the quality of the finished product and the safety of the use of molds and pressure wheels; the crushing length of the raw materials should be controlled within the range of 20mm ~ 50mm to ensure the production of the machine When the resistance between the module and the module is minimized, reactive power loss is reduced and output is increased; raw materials must be input continuously and uniformly to ensure smooth operation of the machine. This device is designed with precision and is not easily damaged. It is a rare good device. I believe you will not regret buying it.

                   The host machine may be stuffy because the material has low moisture content. Too much material is supplied, resulting in overload. Hard objects such as iron blocks enter the module. The module and pressure wheel are severely worn, causing difficulty in discharging. The moisture content of the raw material can be adjusted at any time according to the density of the briquettes. Reduce Supply materials. Remove iron blocks and other hard objects. Adjust the gap, repair or replace the module and pressure wheel. If the discharge hole does not discharge material, it may be because the discharge hole is blocked. The module gap is inappropriate. You can clean the material in the mold and adjust it. Gap, repair or replace the module. If the finished product is not lumpy, it may be because the moisture content of the raw material is too high and the aging reaction time is short. The moisture content of the raw material can be adjusted to increase the aging reaction time. There are at least 3 types of moisture content for debugging.