How To Maintain The Hardware Of The Fuel Pellet Mill?

                    Sawdust pellet machine feed inlet can be set up with permanent magnetic cylinder or iron remover, so as not to affect the service life of the pressure roller, die and center shaft. The temperature of the pellet fuel in the extrusion process is up to 50-85 ℃, the pressure roller is subjected to a lot of passive force in the operation process, but lacks the necessary effective dustproof device.

                    Therefore, the bearings must be cleaned and high temperature resistant grease added every 2-5 working days. The main shaft of the sawdust pellet mill should be cleaned and oiled every one month. The gearbox should be cleaned and maintained every six months. Tightening and replacement of transmission part screws should be carried out at any time.